Installation: Decals/Stickers

---

More Support

• Canva Training
  • Oct 3, 2023 How to Download a Print-Ready PDF from Canva
  • Jun 21, 2023 How to Copy our Print-Ready Canva Files
• Care Instructions
  • Jun 18, 2024 How to Care for Synthetic Menus
• How To
  • Aug 7, 2024 Installation: Decals/Stickers
  • Jun 18, 2024 How to Care for Synthetic Menus
• Miscellaneous
  • Jul 21, 2023 Submitting Tax Exemption Form (Ohio)
• Payment Processing
  • Nov 29, 2022 Paying for Your Order
• Storefront Training
  • Oct 3, 2023 How to Download a Print-Ready PDF from Canva
  • Jul 21, 2023 Submitting Tax Exemption Form (Ohio)
  • Jul 12, 2023 Updating your Password
  • Jun 21, 2023 How to Copy our Print-Ready Canva Files
  • Jun 8, 2022 Placing Orders on the Storefront
  • Mar 11, 2019 Using the Storefront to Get Pricing

PLEASE NOTE: Exterior and interior signage that is not installed by our team is not warrantied and not eligible for returns, exchanges, credits, reprints, or refunds.

Material-Specific Specifications

Standard Vinyl

• The minimum application temperature for this product is 50 degrees F, so ensure that the sticker and car is no colder than that when you go to apply it. 

• The material requires a dry application, so do not use any water/soap/application liquid with it. 

GlassApeel

• This can be applied in most weather temperatures.

• The material requires a wet application, but only use water, no chemicals.

• Spray water on the back of the decal and the application surface before application, then squeegee from the center to the edge to force air/water bubbles out and apply.

• This material is repositionable - remove, clean with water if needed, and reapply.

General Installation Best Practices

• We recommend cleaning the area prior to installation with soap or rubbing alcohol and water. Cleaning products may leave a residue behind that will prevent the sticker from adhering fully. 

• To reduce the chance of bubbles, install cut vinyl or large stickers using the hinge method. Video example included below. 

  • For this method, you’ll place the sticker on the area where you want it to be (with the backing still on it). 

  • Then use masking tape (or any low tack tape) on the center of the sticker to hold it in place (this is your “hinge”). 

  • On one side of the hinge, peel the backer away and cut it off. 

  • Then use a felt squeegee (or similar item) to press the sticker on the masking tape hinge and slowly out to the edge of the sticker. 

  • When that side is done, you’ll remove the rest of the backer and squeegee the other side down, again, going out from that hinge.